The choice of the right cable or line for transmitting signals on your own machine has essential influence on the machine availability. Usually, when determining the instruments of machines and plants, a profound level of attention is given to choosing the right sensors.
For Sure , the user determines which measuring principles are employed for level measurement, which power supply ought to be provided to the device and which type of signal transmission should be used. Usually, the cables shown in the wiring schemes as simple connection lines between sensor and SPS are problematic. This poses a fascinating paradox in the automation technology ? a sensor is tested for highest demands to assure it meets the requirements of the application form, whereas a cable is only regarded as a component which supposedly guarantees a reliable connection under all circumstances.
However, cables and connectors pose just about the most frequent sources of error. This is often where unforeseen potential for increasing machine availability are available. During my span of research I learned that in a higher two-digit percentage of most cases, renowned cable manufacturers traced back sensor failure on machines to mechanical failure of the cable because of faulty installation, handling and especially as a result of selection of an unsuited cable for the precise application. Principally, there is no patent fix for determining which cable and which plug connector is most beneficial suitable for your application.
For example, flexibility demands for cables used in level probes for level measurement in deep wells aren? Practical , whereas the demands on tensile strength in addition to high longitudinal and transverse water tightness are. In level probes, plug connectors are barely ever applied because of the insufficient permanent leak tightness. For machine tools which are create in factory buildings, the easiest cable materials with a straightforward M12 connector are employed. In this case, however, the use of the right cable that permanently withstands ambient conditions such as for example temperature fluctuations and that has resistance against oils and fats can significantly raise the availability of your machine.
The usage of cable assemblies with factory pre-assembled connectors also prevents failure risk through improper on-site assembly. Therefore it is a fallacy that all cables are the same and that any given cable with the sufficient number of wires is suitable for an application.
In another of my previous articles, I drew up a brief overview of probably the most relevant criteria for choosing cables and connectors. Invest some time in specifying the right cable for the application. Take into account the demands your plug link with sensors and PLC must meet. An individually matched wiring concept offers a measurable increase of the device availability and higher safety during operation.
In the event you need assistance or consulting for specifying a suitable pressure sensor and associated cable / connector, feel absolve to contact us.